Silvercrest SUP 128 A1 Manuel de service télécharger pdf (Page 32)

SilverCrest graphics tablet SGT 10.6 A1

30 - English

Replacing the battery

To replace the battery proceed as follows:

1. Remove the cap.

2. Push the cover upwards slightly

and lift it off.

Do not push the cover too far

upwards, as the tabs at the front

could otherwise break off.

3. Replace the used battery with a

new battery (1.5 V, type AAA ).

The positive pole (+) must al-

ways point towards the open end

of the pen.

Ensure the battery is inserted

with the correct polarity.

4. Place the tabs of the cover into

the front of the bottom section

and carefully push down until the

cover snaps into place on the

bottom section. Do not use any

force.

5. Replace the pen cap.

Remember to protect the environment. Used batteries should not be dis-

posed of in domestic waste. They must be taken to a collection point for old

batteries.

Replacing the pen nib

To replace the pen nib proceed as follows:

1. Grip the nib (O) with the nib ex-

tractor (Q) and pull the nib out of

the pen.

2. Push a new nib (O) as far as

possible into the pen.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 197 198

Pas de commentaire

Silvercrest SUP 128 A1 Manuel de service Page 32