Silvercrest SIRD 14 B1 Manuel d'utilisateur télécharger pdf (Page 160)

SilverCrest SIRD 14 B1

158 - English

Before you start

 Remove all protective films from the device and accessories.

 Connect the connector of the power adapter supplied into the DC IN socket [16] on the back

of the Internet Radio.

 Plug the power adapter into an every time easily accessible wall outlet.

When laying the power adapter cable, make sure it cannot cause a trip

hazard.

Inserting the battery into the remote

control

Open the battery compartment on the bottom of the remote

control by sliding the battery compartment cover in the

direction of the arrow. Insert the 3V CR2025 button cell

battery all the way into the battery compartment. Fit the

battery the right way round, with the + sign facing up. This is

shown on a diagram in the battery compartment. Next slide

the battery compartment cover back to its original position.

Replacing the battery

When you need to change the battery, replace it with a new

3V CR2025 button cell battery. Proceed as described in the

previous section.

Internet connection

There are 2 ways to establish an Internet connection for your Internet Radio:

 In WLAN mode, the RF signals from your router are received through the built-in WLAN

antenna.

 In LAN mode, the signals are transferred via a network cable. In this mode, you need to

connect a network cable to your router and the Internet Radio LAN port [15].

Of course, it is more flexible to use the wireless WLAN mode for your Internet Radio. This requires a

wireless 802.11a/b/g/n-compliant network.

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 193 194

Pas de commentaire

Silvercrest SIRD 14 B1 Manuel d'utilisateur Page 160