Silvercrest SRW 250 A2 Manuel d'utilisateur télécharger pdf (Page 78)

SRW 250 A2 Alarm Clock Radio

76 - English

Please note that you can only set the alarm time and

alarm volume while the numbers are flashing on the

display [10]. If no input is made for a few seconds, the

numbers on the display [10] stop flashing and you will

have to repeat the procedure.

Enabling the Alarm

After the you have set the alarm time you want, you can enable the alarm

as follows:

 Press the ALARM1 [3] or the ALARM2 [5] button quickly. The AL1

alarm sound LED [23] or the AL2 alarm sound LED [20] lights up on

the display [10]. The alarm is now enabled for the set time and with

the alarm sound.

 Press the ALARM1 [3] or the ALARM2 [5] button again quickly. The

AL1 alarm radio LED [22] or the AL2 radio [21] lights up on the

display [10]. The alarm is now enabled for the set time and with the

radio.

 To disable the alarm, press the ALARM1 [3] or the ALARM2 [5]

button again. While the alarm is disabled, the AL1 alarm sound LED

[23], the AL1 radio LED [22], the AL2 alarm sound LED [20] and the

AL2 radio LED [21] are off.

In radio alarm mode, the device powers on at the alarm time

set and receives the last frequency and the last volume set. In

buzzer alarm mode the alarm will sound with the volume

assigned to the corresponding alarm function too.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 117 118

Pas de commentaire

Silvercrest SRW 250 A2 Manuel d'utilisateur Page 78