Silvercrest SKF 2300 B2 Manuel d'utilisateur Page 61

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 84
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 60
58
SKF 2300 B2
GB
MT
Troubleshooting
PROBLEM POSSIBLE CAUSE
POSSIBLE
SOLUTIONS
The appliance does not
function.
oder
The control lamp integrated
into the On/Off switch
0
does not glow.
The appliance is not connected
with a mains power socket.
Connect the appliance to
a mains power socket.
The appliance is damaged.
In this case, contact
Customer Services.
The On/Off switch
0 has not
been activated.
Press the On/Off switch 0.
The heat protection function
has been activated.
1. Remove the plug and
allow the appliance
to cool down.
2. Press the reset button
t
on the rear of the con-
trol/heating element 5.
The appliance has switched
itself off during use and
does not allow itself to be
switched back on.
The heat protection function
has been activated.
1. Remove the plug and
allow the appliance to
cool down.
2. Press the reset button
t
on the rear of the con-
trol/heating element 5.
The green control lamp
9
does not glow.
The programmed temperature
for the cooking oil/fat has not
been reached.
Wait a few minutes until the
required temperature has
been reached.
If the malfunction cannot be corrected with the above suggestions, or if you have determined
that the malfunction may have other causes, please make contact with our Customer Service.
Appendix
Disposal of the appliance
Do not dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of European Directive
2002/96/EC.
Dispose of the appliance through an approved disposal centre or at your com-
munity waste facility. Observe the currently applicable regulations. In case of
doubt, please contact your waste disposal centre.
IB_75818_SKF2300B2_LB5.indb 58IB_75818_SKF2300B2_LB5.indb 58 27.08.12 11:2627.08.12 11:26
Vue de la page 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 83 84

Commentaires sur ces manuels

Pas de commentaire