Silvercrest SMA 550 A1 Manuel d'utilisateur télécharger pdf (Page 55)

SMA 550 A1

Cleaning and Care

DANGER - RISK OF ELECTRICAL SHOCK!

►

Before cleaning it, disconnect the plug from the mains power socket!

Otherwise there is the risk of receiving an electric shock!

► NEVER open any housing parts. There are no user-serviceable elements

inside. When the housing is open, there is the risk of receiving a potentially

fatal electrical shock.

NEVER immerse the appliance in water or other liquids! This would

bring about the risk of a potentially fatal electric shock upon the

next use of the appliance should moisture be present in the voltage

conducting elements.

WARNING - RISK OF PHYSICAL INJURY!

► Let the appliance cool down before cleaning it. Risk of burns!

WARNING - PROPERTY DAMAGE!

Do not clean the appliance or parts of it in the dishwasher!

If you do so, the appliance will be damaged beyond repair.

► Do not use abrasive or caustic cleaning agents. These can attack the

surface and damage it beyond repair.

NOTICE

►

Ideally, clean the appliance directly after cooling, so that milk residues can

not dry onto it.

For the ﬁ rst coarse cleaning put some water and a little mild detergent into

the carafe (the whisk used 4/8 is still ﬁ tted). Thereby, pay heed to the

MIN and MAX

- markings.

Start the appliance so that the whisk ploughs 4/8 through the water.

Afterwards, rinse the appliance out with copious clean water.

For a thorough cleaning, proceed as follows:

■ Remove the whisk 4/8 from the appliance to clean it and clean the inside

of the appliance with warm water. Add a little detergent. Wipe the interior

with a soft cloth or sponge. Pay special attention to the area around the

drive shaft. Afterwards, rinse the appliance out with copious clean water.

■ Pull the sealing ring 3 oﬀ of the lid 1 and clean both parts in mild soapy

water. Remove detergent residues with clean water and dry both parts well.

Push the sealing ring 3 back onto the lid 1, so that the outwardly facing

sealing lip is located at the bottom of the lid 1 and the inwardly facing seal-

ing lip engages in the groove of the lid 1.

IB_100076_SMA550A1_CH.indb 52IB_100076_SMA550A1_CH.indb 52 01.04.14 16:4001.04.14 16:40

1 2 ... 50 51 52 53 54 55 56 57 58 59

Pas de commentaire

Silvercrest SMA 550 A1 Manuel d'utilisateur Page 55